Diamond Audio Technology D1 250.2 Manual de Instalação

D1 250.2 | D1 300.4 | D1 400.1AMPLIFIER INSTALLATION MANUAL

10Installing the Remote Level Controller The D1 400.1 comes packaged with a remote level control. This allows you to control the level by attenu-ating

11 Adjustment of Built-In Crossover (All Models)Placing the switch in the HP position sets the amplier to the High Pass mode, enabling freque

042007Diamond Audio WarrantyDiamond Audio Technologies, LLC (DAT) warrants this product to be free from defects in mate-rial and workmanship for a per

2Congratulations!Thank you for choosing a Diamond Audio Technologies D1 Series amplier. We sincerely believe that DAT products offer you outstanding

3Frequency Response: 20Hz to 20KHz +/-3 dBSignal to Noise Ratio: >95dBA (20 to 20kHz)Channel Separation 50dBTHD+N(Total Harmonic

4Connections and ControlsThis section describes how all of the terminals and adjustments of DAT D1 Series ampliers function. D1 250.22-Channel Amplifi

5RCA Input and Pass-Thru Output - These RCA jacks allow for a normal Left and Right channel signal input. Simply connect to the source unit using RCA

6Installation GuidelinesTools and SuppliesListed below are the tools and supplies needed to complete this installation:• Volt/Ohm Meter• Wire stripp

7Mounting LocationsEngine CompartmentNever mount this unit in the engine compartment. Mounting the unit in the engine compartment will void your warra

83) Trim the power cable within 18 inches (45.7mm) of the positive battery post and splice in a in-line fuse holder. DO NOT install the fuse at thi

925A25AFRBRIDGE++– + ––25A FUSEREMGND +12V30A FUSEBRIDGEL R++– + ––REMGND +12VConnecting Multiple SpeakersIf you must connect more than one speaker p